technical information sheet

HYRANGER TS PY

Technical reference: Avis technique HYRENE TS (HYRANGER TS)

Ref.: 1747001
  INTRODUCTION

HYRANGER TS PY is a composite polyester/glass reinforced polymer (SBS) modified bituminous membrane finished on both its upper and lower surfaces with a plastic film.

 
  USAGE

HYRANGER TS PY is used as the first or base layer in a multi-layer waterproofing system. It is installed by the torching method.

PRESENTATION

Rolls of 10 m2 (10 m x 1 m), with a nominal weight of 38 kg.

STORAGE

Rolls to be stored upright and away from heat.

  
 
COMPOSITION
Polyester / glass reinforcement.......................................... 170 gm/m2
Elastomeric (SBS) binder (impregnation and coating).......... 3,400 gm/m2
Surface: Thermo-fusible surface film .................................. 10 gm/m2
Thermo fusible film under surface ....................................... 10 gm/m2


CHARACTERISTICS

binder
Melting point (ring & ball) NFT 66.008 ................................ 125° C
Penetration @ 25° C NFT 66.004 ..................................... 40/10 mm
Cold bend 20 mm f mandrel, no cracking @ ..................... - 25° C
Elongation at break 1500 %

CHARACTERISTICS
finished product
Tensile strength (NFG 07.0010) : length/width .................... 750/750 N/5 cm
Elongation at break (NFG 07.001) : length/width ................. 35/35 %
Cold bend 20 mm f mandrel, no cracking @....................... - 15° C
Free shrinkage................................................................. < 0.05 %
Slump resistance, vertical................................................. 100° C
 
  The manufacturer reserves the right to modify, at any time, the characteristics of its products. The characteristics mentioned above are indicative only with tolerances in accordance with current standard practice.  
 

West Road, Ransomes Europark, Ipswich, Suffolk, IP3 9SX

Tel: 01473 724056 - Fax 01473 723263

email sales@axterltd.co.uk

 13 February 1992